Views: 0 Author: Site Editor Publish Time: 2022-12-27 Origin: Site
solar garden light is suitable for lighting and decoration of urban roads, commercial and residential quarters, parks, tourist attractions, squares, etc. The commercial lighting system in the above-mentioned places can also be transformed into a solar lighting system according to user needs.
How to install the battery of solar garden light?
What are the installation precautions for solar garden light?
What is the service life of solar garden light?
First, check whether the packaging of the battery of solar garden light is damaged, and then carefully unpack the battery to check whether the battery is in good condition one by one; and check the factory date of the battery. The voltage of the installed battery is DC12V, 80AH. Two of the same model and the same specification are connected in series to provide 24V power supply. Put the two batteries into the buried box (type 200). After the outlet of the buried box is glued, fasten the protective tube (with steel wire water supply pipe) step by step, and use silicone sealant after the lead wire at the other end of the protective tube. Sealed to prevent water ingress. The size of the pit for digging and burying the box: adjacent to the base of the garden light, 700MM deep, 600MM long and 550MM wide. Buried tank pool: use single brick cement to surround, put the buried tank with batteries into the pool, lead out the line pipe, and cover it with a cement board. Batteries must be connected to each other with the correct polarity and must be firmly connected. After the battery pack is connected, connect the positive and negative poles of the battery pack to the positive and negative poles of the power supply controller and connect them firmly. Then apply a layer of Vaseline to the joint.
Controller installation: The controller adopts a special controller for solar power supply. When connecting the wire, first connect the terminal of the battery on the controller, then connect the photovoltaic panel wire, and finally connect the load terminal. Be sure to pay attention to the battery, the + and - poles of the photovoltaic panel and the load cannot be reversed, and the connecting lines of the photovoltaic panel and the battery cannot be short-circuited. The controller is placed in the lamp post, fixed with bolts, and the warehouse door on the lamp post is locked.
Lampholder base: poured concrete, label: C20. Dimensions: length 400mm*width 400mm*depth 500mm, pre-embedded screw inspection M16mm, length 450mm, with two reinforcing ribs of Φ6mm in the middle. (See Figure 3)
Laying of electric wires: All connecting wires used are threaded through pipes, and they can be routed from the roof, which can be led down from the threading well, or can be routed along the downspout from the floor. Use ?25mm threading pipe for off-roof cables, and 20mm for underground wiring. Threading pipes, pipe joints, elbows, tee joints, and sealing with glue. Use metal water supply hoses to connect special places to make them waterproof. Most of the connecting wires of solar garden light use BVR2*2.5mm2 sheathed wires.
The service life of solar garden light is more than 25 years; the service life of light poles can also reach more than 30 years; solar street lights use LED light sources. 10 hours of use, then at least 10 years of life. And so on some reasons that will affect the service life of solar garden lights. In general, the service life of our solar garden lights is still very good, and they are most suitable for use as street lights.
Haoxintai Lighting is dedicated to the production, R & D and sales of LED solar light, We manufacture LED solar street light, solar flood light, solar garden light, solar ceiling light,solar fan and other outdoor lighting products.
